efa fabric device
add-bulk
Adds multiple devices to a
fabric.
Syntax
efa fabric device
add-bulk
[
--name
fabric-name
|
--ip
device-ip |
--leaf
list
|
--border-leaf
list
|
--three-stage-pod
name
|
--five-stage-pod
name
|
--spine
list |
--super-spine
list
|
--username
username
|
--password
password
|
--rack
name
|
--border-leaf-rack
list
|
--border-leaf-ip
device-ip
]
Parameters
- --border-leaf
list
- Specifies the comma-separated list of border
leaf IP addresses or host names.
- --border-leaf-ip
device-ip
- Specifies the pair of border
leaf device IPs for the rack.
- --border-leaf-rack
list
- Specifies the border leaf
rack name.
- --five-stage-pod
name
- Specifies the name of the super-spine
pod.
- --ip
device-ip
- Specifies the pair of device IP addresses
for rack.
- --leaf
list
- Specifies the comma-separated list of leaf IP
addresses or host names.
- --name
fabric-name
- Specifies the name of the fabric.
- --password
password
- Specifies the password for the list of
devices.
- --rack
name
- Specifies the rack name.
- --spine
list
- Specifies the comma-separated list of spine
IP addresses or host names.
- --super-spine
list
- Specifies the comma-separated list of super
spine IP addresses or host names.
- --three-stage-pod
name
- Specifies the name of the leaf or spine
pod.
- --username
username
- Specifies the user name for the list of
devices.
Usage Guidelines
Ensure you perform the following operations before running this command:
- Run the efa inventory device register --ip
<list-of-device-ips> command.
- Run the efa inventory device interface list --ip
<device-ip> command. In the output of the command, verify
that the states of the port links are as you expected (in the Admin Status
and Oper Status fields). If not, manually check the physical cabling and fix
any issues. Then continue with the efa fabric device
add-bulk operation.
If you provide a user name and password, devices are automatically registered with the
inventory service.
If you do not provide a user name and password, you must explicitly register the
devices with the inventory service.
A single “three-stage-pod” and “five-stage-pod” can be provided each time you run the
command.
If, during device registration, the device is found to be in maintenance mode, then
an error is returned and registration fails. To take the device out of maintenance
mode before reattempting device registration, you must perform a manual procedure.
Examples
This example adds two leaf IP addresses
and two border leaf IP addresses to the specified
fabric.
efa fabric device add-bulk --name BLR_FABRIC --leaf 10.24.48.131,10.24.51.135
--border-leaf 10.24.51.131,10.25.225.58 --spine 10.24.80.139 --username admin --password password
